Changes

====General Procedure====

====General Procedure====

# Tape existing stencil to acrylic scrap  

# Tape existing stencil to a piece of acrylic scrap. The stencil will only allow abrasion in the areas desired.

# Open the cabinet door.

# Open the cabinet door.

# Place stencil/acrylic into sandblast cabinet

# Place stencil/acrylic into sandblast cabinet

# After placing parts in the cabinet, make sure secure the door with latch properly

# After placing parts in the cabinet, make sure to secure the door.  If the door is left open it will create a cloud of dust that should not be inhaled.

# Turn on the cabinet light and fan. Switch is located on the top left of the machine

# Turn on the cabinet light and fan switch. The switch is located on the top left of the machine.

# Insert your arms into the gloves and position yourself for a clear view into the cabinet.

# Insert your arms into the gloves and position yourself to have a clear view into the cabinet

# Picking up the parts and gun, manually aim where the stencil doesn't cover the acrylic. Do not point the gun at your gloves or the window.

# Picking up the parts and gun, manually aim where the stencil doesn't cover the acrylic

# Position your foot in the foot pedal mechanism. Once pedal is depressed sand will blast out of the gun.

# Position your foot in the foot pedal mechanism. Once pedal is depressed sand will blast out of the gun

# When finished, turn the machine off.

# When finished, turn the machine off

# Before removing parts, wait 5-10 mins for the dust in the cabinet to settle.

# Before removing parts, wait 5-10 mins for the dust in the cabinet to settle

# Once you remove parts make sure to close cabinet door and power off the light and fan.

# Once you remove parts make sure to close cabinet door and power off the light and fan

==Safety==

==Safety==