53
edits
Changes
Jump to navigation
Jump to search
mLine 170:
Line 170: − + Line 191:
Line 191: − + − #
no edit summary
#'''Aligning the Paste'''
#'''Aligning the Paste'''
##This process will help the Voltera know where it needs to print solder. The user gives it two locations where the pads should go, and the Voltera can use the Gerber files to determine where else pads need to go.
##This process will help the Voltera know where it needs to print solder. The user gives it two locations where the pads should go, and the Voltera can use the Gerber files to determine where else pads need to go.
##At this time, retrieve the solder paste from the fridge and set it out to warm. The correct paste is labeled with a '''orange''' sticker.
##At this time, retrieve the solder paste from the fridge and set it out to warm. The correct paste is labeled with an '''orange''' sticker.
##Take the board back to the Voltera and clamp the board into place. Again, you should not be able to move the board after it is clamped.
##Take the board back to the Voltera and clamp the board into place. Again, you should not be able to move the board after it is clamped.
##Open the Voltera application and choose "Solder," and choose the proper paste. In this case you want the '''orange'''-labeled paste.
##Open the Voltera application and choose "Solder," and choose the proper paste. In this case you want the '''orange'''-labeled paste.
##Unclamp the board from the Voltera. Remember that you are handling a board with wet paste. Clean up!
##Unclamp the board from the Voltera. Remember that you are handling a board with wet paste. Clean up!
##You are now done with the PCB Printer! Refer to the Pick and Place as well as the Reflow Oven wikis for the remainder of the process.
##You are now done with the PCB Printer! Refer to the Pick and Place as well as the Reflow Oven wikis for the remainder of the process.
# '''18658'''
# '''18658'''
## The board consists of a button, a 680Ω resistor, and an LED. Attach a fixed 5VDC connection to the + and -, and the LED should illuminate.
## The board consists of a button, a 680Ω resistor, and an LED. Attach a fixed 5VDC connection to the + and -, and the LED should illuminate.
==Safety==
==Safety==