Changes

== Safety ==

== Safety ==

* General shop protocol is important when using the mill. Long hair, long sleeves, jewelry, gloves, and lanyards are all risks to be wrapped up by the spindle and should not be worn.   

* General shop protocol is important when using the mill. Long hair, long sleeves, jewelry, gloves, and lanyards are all risks to be wrapped up by the spindle and should not be worn.   

* Always make sure that there is plenty of space between the cutting tool and the work piece before turning on the mill. If the tool comes into contact with the work piece before getting up to speed and is set deeper than the maximum cutting depth things will break.     

* Always make sure that there is plenty of space between the cutting tool and the work piece before turning on the mill. If the tool comes into contact with the work piece before getting up to speed and is set deeper than the maximum cutting depth, things will break.     

* At times your work piece may be obscured by metal chips while cutting. Do not remove them while the machine is running. Turn of the mill, wait till it comes to a complete stop, and then remove the chips. There are some brushes on the tool rack that may be helpful for removing stubborn chips.     

* At times your work piece may be obscured by metal chips while cutting. Do not remove them while the machine is running. Turn off the mill, wait till it comes to a complete stop, and then remove the chips. There are some brushes on the tool rack that may be helpful for removing stubborn chips.     

* The milling process is great at creating sharp edges. Be aware of this when handling the work piece and make sure to deburr any sharp edges.

* The milling process is great at creating sharp edges. Be aware of this when handling the work piece and make sure to deburr any sharp edges.

* Never make contact with the cutters as they are razor sharp and will cut you.

* Never make contact with the cutters as they are razor sharp and will cut you.

==Troubleshooting==

==Troubleshooting==

* Not cutting smoothly - Check that the spindle is set to the proper direction. This will cause the tool to not cut properly and will damage the tool. Check that the tool is sharp and the cut depth is not to large as well. Adding cutting oil will also improve the cut.  

* Not cutting smoothly - Check that the spindle is set to the proper direction. This will cause the tool to not cut properly and will damage the tool. Check that the tool is sharp and the cut depth is not too large as well. Adding cutting oil will also improve the cut.  

* Can't reach low spindle speeds - If you adjust the speed dial to a low spindle speed but the spindle is still moving fast then the mill must be switched into low range. Stop the mill, flip the lever on the right side of the machine to low, and then turn the mill back on. Make sure to turn on switch to low when the mill is in low range or the spindle will spin backwards.  

* Can't reach low spindle speeds - If you adjust the speed dial to a low spindle speed but the spindle is still moving fast then the mill must be switched into low range. Stop the mill, flip the lever on the right side of the machine to low, and then turn the mill back on. Make sure to turn on switch to low when the mill is in low range or the spindle will spin backwards.  

* Difficult to shift to low range - At times it can difficult to lock the lever into place when switching between high and low range. If this occurs, twist the spindle slightly while switching the lever so that it will lock in place. Twisting the spindle helps the internal gears lock into place properly.  

* Difficult to shift to low range - At times it can difficult to lock the lever into place when switching between high and low range. If this occurs, twist the spindle slightly while switching the lever so that it will lock in place. Twisting the spindle helps the internal gears lock into place properly.