479
edits
Changes
Jump to navigation
Jump to search
Line 62:
Line 62: − + Line 69:
Line 69: +
→Troubleshooting
# When the tray opens up after baking a board, be patient and let the board cool down. If you handle it while it is too hot, it can burn you and shift your components (not good).
# When the tray opens up after baking a board, be patient and let the board cool down. If you handle it while it is too hot, it can burn you and shift your components (not good).
# Once you are finished using the Reflow Oven, clean the inside and turn it off. '''RESET THE SPACE'''.
# Once you are finished using the Reflow Oven, clean the inside and turn it off. '''RESET THE SPACE'''.
# If you do not want to risk being burnt by the rails when you place your board in the oven, open the tray and place your board '''BEFORE''' selecting a profile.
# If you do not want to risk being burnt by the rails when you place your board in the oven, open the tray and place your board '''BEFORE''' beginning the baking process.
==Certification==
==Certification==
==Troubleshooting==
==Troubleshooting==
There are little to no issues to run into while using the oven. The most common issue is failure to select the correct profile, which results in non-hardened traces and pads. Remember, Green is V1 Ink, Orange is V1 Paste, and blue is SN63Pb37. If this happens, simply bake the board again using the correct profile.
==Maintenance==
==Maintenance==