91
edits
Changes
Jump to navigation
Jump to search
Miller Spectrum 875 Plasma Cutter (view source)
Revision as of 15:20, 11 February 2019
, 6 years ago→Test
Line 21:
Line 21:
Test+
Wow look at all these tests.
Wow look at all these tests.
−= Test =
+= Procedures: =
−# Place fume hood over the area you will be welding at
+# Turn air on
+# Turn plasma cutter on
+# Attach ground clamp
+# Measure thickness of material being cut and refer to chart for current setting on machine
+# Set the current on the plasma cutter
+# Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down.
+# Raise the trigger lock and press the trigger, this will engage the pilot arc
+# Once the cutting starts, begin to slowly move the torch across the metal
+# Adjust your speed so the sparks go thru the metal and out the bottom of the cut
+# At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger
+# Turn off machine
+# Turn off air
+# Disconnect ground clamp