142
edits
Changes
Jump to navigation
Jump to search
Line 36:
Line 36: − + − + − + − + − + − + − + − + − + − + − + + + + + + + + + + + + + + +
→Mentors Only
==Mentors Only==
==Mentors Only==
*How to use bath:[[File:Bath_Controls.jpg|200px|thumb|right|Bath Controls Panel.]]
**How to use bath:
**Flip the black switch to turn the bath on
***ALWAYS USE SAFETY ATTIRE.[[File:Bath_Controls.jpg|227x227px|thumb|right|Bath Controls Panel.|link=https://maker-hub.georgefox.edu/wiki/File:Bath_Controls.jpg]]
**Then press
****Flip the black switch (inside the yellow rectangle) to turn the bath on
**Which button to press
****Then press the button circled in red to start the heating process
**What to do if it beeps--refill with water
****The red knob (circled in cyan) should always be set to 70 degrees Celsius
**Use mesh bags
****Keep the lid shut as often as possible
**You can lift out the cage
****Place the part inside of a mesh bag, tie the strings of the mesh bag to the side handles, allow the part to soak in the bath for several hours
*Tell Ben, Gabi, or Justin if you think the solution should be switched, do not do it yourself
*****Mesh bags are located in the small drawer next to the sink
*What to do if the bath appears to be leaking
****When removing parts:
*What to do in the event of a spill
*****If needed, the basket can be lifted out and removed so that parts can be sifted through in the air instead of the solution. If you do remove basket, removed the lid first and place it in the sink. Next, lift the basket, let it drain above the bath so that it drips into the bath, then once it is barley dripping, the basket can be transferred to the sink.
*How to use the spill kit
*****Wash the mesh bag and part thoroughly. Use paper towels to dry the part and let the part sit on paper towels and drain for a couple hours. Always inform the part's creator to wash their hands after handling the part and before eating or touching their eyes/face.
*****Replace the basket and lid.
**What to do if the bath is beeping:
***This means the bath is low on water (below 1.5 horizontal holes of the basket inside)
***Take the clear bucket under the sink and use it to fill the bath until the fluid level inside is only 1.5 horizontal basket holes from the top
**Tell Ben, Gabi, or Justin if you think the solution should be switched, do not do it yourself
**What to do if the bath appears to be leaking:
***Immediately inform the Aces of the Lab and/or Justin
***This would mean there is a collection of water inside of the grey catch tray underneath the bath.
**What to do in the event of a spill
***Evacuate the lab and shut it down until the spill has been properly cleaned
***Immediately inform the Aces of the Lab and/or Justin; if unavailable and the spill is large then contact Security
***Use the spill kit
****There should be instructions inside
****Make sure you are wearing safety attire
==For Prototype Lab Aces and Bath Ace Only==
==For Prototype Lab Aces and Bath Ace Only==