1,341
edits
Changes
Jump to navigation
Jump to search
Line 165:
Line 165: + + + + + + + + + + + + +
→Level 1
##Quit the Voltera app.
##Quit the Voltera app.
##Unclamp the board from the Voltera. Remember that you are now handling a board with wet paste.
##Unclamp the board from the Voltera. Remember that you are now handling a board with wet paste.
#Pick and PLace
##Clamp the board.
##Power on the Pick and Place. The switch is on the back
##Click place. Click Man
##To move the turntable, select turntable, and use the arrow keys to move it cw or ccw.
##The necessary components should be are stocked in the slots in the turntable.
##Turn on the Marshall monitor.
##The pick and place is a like a vacuum machine. Its operation is straightforward.
##Move the ganrty to the desired component. Press down (but not all the way) to stick the nozzle to the component. Move the gantry back to board. Move the component so it appears to be close the pads and about half a cm above it. Turn the brake on with the arrow keys. Use the fine adjustment knobs at the bottom of the machine along with the monitor to perfectly align the component. Remember you can move the camera to look down two different axes.
##When aligned, press place using the arrow keys.
##Move the turnable using the arrow keys to retreive your next part. Repeat steps 8 and 9 until your board is complete.
##Remove your board from clamps.
##Turn off the pick and place
<br /><br />
<br /><br />