Changes

# ''Software setup''

# ''Software setup''

## Power on the Voltera.

## Power on the Voltera.

## Open the Voltera Windows application.

## Open the Voltera Windows application.

## Select "Print" and then "Simple."

## Select "Print" and then "Simple."

## Select the proper ink. Reference the <u>Current Inks and Pastes</u> for information on the what the PCB lab is currently stocked with.

## Select the proper conductive ink. This is the same conductive ink you acquired in step 1.3.

## Load the ink file. This is the Top Layer Gerber file. Download it <u>here.</u>

## Load the ink file. This is the Top Layer Gerber file. Download it <u>here.</u>

## Click "Next."

## Click "Next."

# ''Positioning and probing''

# ''Positioning and probing''

## Click "Outline." This will show you where the Voltera thinks the board is. It will move the probe around the printer surface.

## Click "Outline." This will show you where the Voltera thinks the board is. It will move the probe around the printer surface.

## Repeat step one until the outline is centered with the board. Click and drag the circuit in the Voltera application to move the outline. '''You MUST ensure the outline does not collide with the clamps!'''

## Repeat step one until the outline is centered with the board. Click and drag the circuit in the Voltera application to move the outline.  

## '''You MUST ensure the outline does not collide with the clamps AND does not exceed the dimensions of the board!''' Do NOT proceed until this is checked!

##  

##  

=== Level 2 ===

=== Level 2 ===