1,341
edits
Changes
Jump to navigation
Jump to search
Line 26:
Line 26: + + Line 32:
Line 34: + + + + + + + + + + + + + + + +
→Level 1
* [[Media:Voltera_V-One_Manual_English.pdf|User Manual]]
* [[Media:Voltera_V-One_Manual_English.pdf|User Manual]]
* [https://support.voltera.io/hc/en-us/sections/115001325748-User-Guides User Guides]
* [https://support.voltera.io/hc/en-us/sections/115001325748-User-Guides User Guides]
== Current Inks and paste ==
== Training ==
== Training ==
Successful completion of level 1 training will grant access to:
Successful completion of level 1 training will grant access to:
* Using the Voltera to create single-sided boards with NO vias or holes.
* Using the Voltera to create single-sided boards with NO vias or holes.
Upload gerber file here?
# Clamping the substrate.
## Acquire a 1.5" by 2" blank board. They are located in the one of the drawers.
## Slide the board underneath the clamps on the Voltera, push the clamps towards each other, and finger-tighten the thumb screws.
# Software setup.
## Power on the Voltera.
## Select "Print" and then "Simple."
## Select the proper ink. Reference the "Current Inks and Pastes" for information on the what the PCB lab is currently stocked with.
## Load the ink file. This is the Top Layer Gerber file. Download it <u>here.</u>
## Click "Next."
# Cleaning the sensors.
## Take a cue tip and dip it into the isopropyl alcohol. The cue tip should be moist, but NOT soaked. Dab the cue tip on a paper towel to dry it slightly.
## Clean the calibration switches by rubbing them with the cue tip.
# Mounting the probe.
=== Level 2 ===
=== Level 2 ===