83
edits
Changes
Jump to navigation
Jump to search
Line 68:
Line 68: − + − + Line 81:
Line 81: − +
→General Procedure
Adjusting the Temperature and Time:
Adjusting the Temperature and Time:
# Press the (Mode) select button in the center of the Control Panel so that the (SET) and (TEMP) lights located next to the display will illuminate. This process can be seen in Figure 2.
# Press the (Mode) select button in the center of the Control Panel so that the (SET) and (TEMP) lights located next to the display will illuminate. This process can be seen in Figure 2.
# Press the (+) or (-) button to raise or lower the temperature setting.The LED Display will show changes as you make them.
# Press the (+) or (-) button to raise or lower the temperature setting. The LED Display will show changes as you make them.
# Once you have adjusted the temperature, press the (Mode) Select button again to advance to Time Mode. The (SET) and (TIME) lights will illuminate. If you do not want to adjust the temperature first you will need to press (Mode
# Once you have adjusted the temperature, press the (Mode) Select button again to advance to Time Mode. The (SET) and (TIME) lights will illuminate. If you do not want to adjust the temperature first you will need to press (Mode).
# Adjust the time in the same manner you adjusted the temperature.
# Adjust the time in the same manner you adjusted the temperature.
# Select the desired time and push the Mode Select button again to exit. All lights will be off and the press will return to PRINT mode.
# Select the desired time and push the Mode Select button again to exit. All lights will be off and the press will return to PRINT mode.
# Remove the material from the heat press.
# Remove the material from the heat press.
# Carefully pull off the heat transfer paper, making sure to keep a steep angle so that the graphic does not peel off. This can be done while the material is hot or cold.
# Carefully pull off the heat transfer paper, making sure to keep a steep angle so that the graphic does not peel off. This can be done while the material is hot or cold.
# Reset the space by turning off the heat press, leaving it open, and wiping off any dust or other debris as needed.
# Reset the space by turning off the heat press, leaving it open, and wiping off any dust or other debris as needed.
== Certification ==
== Certification ==