124
edits
Changes
Jump to navigation
Jump to search
Line 55:
Line 55: − +
→Training
====Operation====
====Operation====
The Fablight is a simple machine to use for cutting flat stock. A part is saved as a DXF file and then imported to FabCreater where features can be set to cut, engrave, raster, or just be reference geometry. In FabCreator, tabs can be added to make sure small parts don't fall to the bottom of the machine along ''[along what?''] and material properties are set as well. Once the part is set up correctly it is saved to a USB drive to be transferred to the machine. Most of the interactions with the machine happen through the touchscreen which makes previewing and cutting the job a simple task. Cutting tube stock is more intricate. The Fablight Solidworks Plugin is used to make a 2d DXF out of the 3d Solidworks model by essentially unwrapping the tube until it is one flat piece. This DXF is then wrapped back up into a 3d part in FabCreater before being sent to the machine. Only use the Fablight Solidworks Plugin when cutting or engraving tube stock. When cutting tube stock you will want to cut as close to the chuck as possible to avoid waste.
The Fablight is a simple machine to use for cutting flat stock. A part is saved as a DXF file and then imported to FabCreater where features can be set to cut, engrave, raster, or just be reference geometry. In FabCreator, tabs can be added to make sure small parts don't fall to the bottom of the machine along ''[along what?''] and material properties are set as well. Once the part is set up correctly it is saved to a USB drive to be transferred to the machine. Most of the interactions with the machine happen through the touchscreen which makes previewing and cutting the job a simple task. Cutting tube stock is more intricate. The Fablight Solidworks Plugin is used to make a 2D DXF out of the 3D Solidworks model by essentially unwrapping the tube until it is one flat piece. This DXF is then wrapped back up into a 3D part in FabCreater before being sent to the machine. Only use the Fablight Solidworks Plugin when cutting or engraving tube stock. When cutting tube stock you will want to cut as close to the chuck as possible to avoid waste.
====Demonstration====
====Demonstration====