1,947
edits
Changes
Jump to navigation
Jump to search
Line 63:
Line 63: + + + + + + + + + +
→General Procedure
6. Using the blade speed adjustment knob you can set the blade strokes per minute. The EX-21 is capable of producing 400 to 1550 strokes per minute. Normally harder/thicker material will require a slower blade speed. Set the blade around 800 to start with. If you notice burn marks slow down the speed.
6. Using the blade speed adjustment knob you can set the blade strokes per minute. The EX-21 is capable of producing 400 to 1550 strokes per minute. Normally harder/thicker material will require a slower blade speed. Set the blade around 800 to start with. If you notice burn marks slow down the speed.
7. Gently feed the material into the blade while aligning your marks with the blade. Slowly follow the line with the blade and cutout around the letter.
8. Adjust the blade oscillation speed as needed. If the material is showing burn marks you need to slow down the speed.
9. When you finish cutting out the letter turn off the power switch.
10. Detention the blade by flipping the lever above the blade.
11. Reset the space.
==Safety==
==Safety==