Changes

  |Is used in domain=Wood

  |Is used in domain=Wood

  |Has name={{PAGENAME}}

  |Has name={{PAGENAME}}

  |Has icon=File:Hand Router.png

  |Has icon=File:Router Table Icon 2.png

  |Has icondesc=

  |Has icondesc=Router Table Icon 2.png

  |Has iconwname=

  |Has iconwname=Router Table Icon 2.png

  |Has image=File:Router Table.jpg

  |Has image=File:Router Table.jpg

  |Has imagedesc=

  |Has imagedesc=

  |Has model=PM-P254

  |Has model=PM-P254

  |Has serial number=107015

  |Has serial number=107015

  |Has ace=Needed;Needed

  |Has ace=Needed;gdowler@georgefox.edu

}}

}}

[[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|140px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]]

[[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|140px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]]

[[File:Safety First HD2.png|left|150px]]

[[File:Safety First HD2.png|left|150px]]

Although the router table displays the SawStop logo, it does not have the SawStop technology. If your fingers come in contact with the spinning bit, the bit will not stop and it will be a very bad day for you. Remember... SAFETY FIRST!

Although the router table displays the SawStop logo, it does not have the SawStop technology. If your fingers come in contact with the spinning bit, the bit will not stop and it will be a very bad day for you. Remember... SAFETY FIRST!

 

* Always wear safety glasses in the wood shop and wear hearing protection as applicable.

* Always wear safety glasses in the wood shop and wear hearing protection as applicable.

* Always unplug the router table when changing the bit.

* Always unplug the router table when changing the bit.

==Troubleshooting==

==Troubleshooting==

Occasionally routing can leave burn marks on the workpiece. This can happen when the workpiece is fed through the router too slowly, but it can also mean that the bit in the router has become dull. Let a shop supervisor know if a bit seems dull. Sometimes the burning is due to build up of resin and other gunk (a technical term) on the backside of the cutter which insulates the bit and allows for more heat to build up. Inspect the router bit before using, and make sure it looks clean. If the bit seems both clean and sharp, the cause of burning on you workpiece is either a feed rate that is too slow or a router bit speed that is too high.

Occasionally routing can leave burn marks on the workpiece. This can happen when the workpiece is fed through the router too slowly, but it can also mean that the bit in the router has become dull. Let a shop supervisor know if a bit seems dull. Sometimes the burning is due to build up of resin and other gunk (a technical term) on the backside of the cutter which insulates the bit and allows for more heat to build up. Inspect the router bit before using, and make sure it looks clean. If the bit seems both clean and sharp, the cause of burning on your workpiece is either a feed rate that is too slow or a router bit speed that is too high.

If you are shaping end grain with a router table, use a square push block behind your workpiece to support the trailing edge and prevent tearout.

If you are shaping end grain with a router table, use a square push block behind your workpiece to support the trailing edge and prevent tearout.