Changes

## In this case, to make an adjustment, the ink height was set to a Z of 0.09 mm and the flow was set to an E of -10 um.  

## In this case, to make an adjustment, the ink height was set to a Z of 0.09 mm and the flow was set to an E of -10 um.  

## '''You may need to do the same or make different adjustments. Whatever you do, do NOT run the nozzle into the board! The nozzle will break!'''

## '''You may need to do the same or make different adjustments. Whatever you do, do NOT run the nozzle into the board! The nozzle will break!'''

## If an adjustment was made, '''wipe the board clean with a paper towel (shown below)''' and repeat step 9. [[File:Voltera wipe.jpg|border|none|300x300px]] <br />

## If an adjustment was made, '''wipe the board clean with a paper towel (shown below)''' and repeat step 9. [[File:Voltera calibrate_wipe.jpg|border|none|300x300px]] <br />

## The example below is a more acceptable test print. Strive for this consistency. If your board looks right, proceed. [[File:Voltera calibrate_better.jpg|border|none|300x300px]] <br />

## The example below is a more acceptable test print. Strive for this consistency. If your board looks right, proceed. [[File:Voltera calibrate_better.jpg|border|none|300x300px]] <br />

## Click "Next."

## Click "Next."

# ''Top Layer Print''

# ''Top Layer Print''

## The Voltera will print what is green. Ensure the portion you want to print is selected. Blue lines will not be printed. (Insert pic that i snipped)

## The Voltera will print what is green. Ensure the portion you want to print is selected. Blue lines will not be printed. (Insert pic that i snipped)

## Click "Start." Let the Voltera finish its process. If a portion of the print fails or is incorrect, you can stop mid-print, or wait until it is finished and redo that selection. Also shown below is an example of a portion of ink that globbed up. The portion was wiped and can be reprinted [[File:voltera_laying_ink.jpg|300x300px|thumb|right|Step]] <br /> [[File:voltera_laying_ink.jpg|300x300px|thumb|right|Step]] <br />

## Click "Start." Let the Voltera finish its process. If a portion of the print fails or is incorrect, you can stop mid-print, or wait until it is finished and redo that selection. Also shown below is an example of a portion of ink that globbed up. The portion was wiped and can be reprinted [[File:voltera_laying_ink.jpg|300x300px|thumb|right|Step]] <br /> [[File:voltera_print_blob.jpg|300x300px|thumb|right|Step]] <br /> [[File:voltera_print_redo.jpg|300x300px|thumb|right|Step]] <br />

## Remove the conductor, replace the cap, AND PUT IT IN THE FRIDGE.

## Remove the conductor, replace the cap, AND PUT IT IN THE FRIDGE.

## When you reach the "Flip Board," you are done. Quit the voltera app

## When you reach the "Flip Board," you are done. Quit the voltera app