Changes

Jump to navigation Jump to search
Line 115: Line 115:  
## In this case, to make an adjustment, the ink height was set to a Z of 0.09 mm and the flow was set to an E of -10 um.  
 
## In this case, to make an adjustment, the ink height was set to a Z of 0.09 mm and the flow was set to an E of -10 um.  
 
## '''You may need to do the same or make different adjustments. Whatever you do, do NOT run the nozzle into the board! The nozzle will break!'''
 
## '''You may need to do the same or make different adjustments. Whatever you do, do NOT run the nozzle into the board! The nozzle will break!'''
## If an adjustment was made, '''wipe the board clean with a paper towel''' and repeat step 9.
+
## If an adjustment was made, '''wipe the board clean with a paper towel (shown below)''' and repeat step 9. [[File:Voltera wipe.jpg|border|none|300x300px]] <br />
 
## The example below is a more acceptable test print. Strive for this consistency. If your board looks right, proceed. [[File:Voltera calibrate_better.jpg|border|none|300x300px]] <br />
 
## The example below is a more acceptable test print. Strive for this consistency. If your board looks right, proceed. [[File:Voltera calibrate_better.jpg|border|none|300x300px]] <br />
 
## Click "Next."
 
## Click "Next."
Line 122: Line 122:  
# ''Top Layer Print''
 
# ''Top Layer Print''
 
## The Voltera will print what is green. Ensure the portion you want to print is selected. Blue lines will not be printed. (Insert pic that i snipped)
 
## The Voltera will print what is green. Ensure the portion you want to print is selected. Blue lines will not be printed. (Insert pic that i snipped)
## Click "Start." Let the Voltera finish its process. If a portion of the print fails or is incorrect, you can stop mid-print, or wait until it is finished and redo that selection. Fig 3 is an example of a portion of ink that globbed up. The portion was wiped and can be reprinted [[File:voltera_laying_ink.jpg|300x300px|thumb|right|Step]]
+
## Click "Start." Let the Voltera finish its process. If a portion of the print fails or is incorrect, you can stop mid-print, or wait until it is finished and redo that selection. Also shown below is an example of a portion of ink that globbed up. The portion was wiped and can be reprinted [[File:voltera_laying_ink.jpg|300x300px|thumb|right|Step]] <br /> [[File:voltera_laying_ink.jpg|300x300px|thumb|right|Step]] <br />
 
## Remove the conductor, replace the cap, AND PUT IT IN THE FRIDGE.
 
## Remove the conductor, replace the cap, AND PUT IT IN THE FRIDGE.
 
## When you reach the "Flip Board," you are done. Quit the voltera app
 
## When you reach the "Flip Board," you are done. Quit the voltera app
1,341

edits

Navigation menu