1,341
edits
Changes
Jump to navigation
Jump to search
Line 101:
Line 101: − + − + Line 111:
Line 111: − + Line 119:
Line 119: − +
→Level 1
## '''You MUST ensure the outline does not collide with the clamps AND does not exceed the dimensions of the board!''' Do NOT proceed until this is checked!
## '''You MUST ensure the outline does not collide with the clamps AND does not exceed the dimensions of the board!''' Do NOT proceed until this is checked!
## Click "Next."
## Click "Next."
## Click "Probe" and wait for the Voltera to finish its measurements. [[File:Voltera mount_probing.jpg|border|none|300x300px]] <br />
## Click "Probe" and wait for the Voltera to finish its measurements. [[File:Voltera probing.jpg|border|none|300x300px]] <br />
## Click "Next."
## Click "Next." <br /><br />
## Remove the probe, replace the cap, place the probe back in the drawer, and click "Next."
## Remove the probe, replace the cap, place the probe back in the drawer, and click "Next."
# ''Priming the Conductor''
# ''Priming the Conductor''
## Click "Advanced." Start with the Z at 0.10 mm and the E at 0 um. Adjust the Voltera to these values.
## Click "Advanced." Start with the Z at 0.10 mm and the E at 0 um. Adjust the Voltera to these values.
## Click "Calibrate."
## Click "Calibrate."
## The Voltera will lay down a test print. Pay close attention to the amount and consistency of the ink. [[File:Voltera printing.jpg|border|none|300x300px]] <br />
## The Voltera will lay down a test print. Pay close attention to the amount and consistency of the ink. [[File:Voltera calibrate.jpg|border|none|300x300px]] <br />
## Fig. 1 has slightly too much ink. Notice how a portion of the horizontal lines touch and some parts of the ink glob up.
## Fig. 1 has slightly too much ink. Notice how a portion of the horizontal lines touch and some parts of the ink glob up.
## In this case, to make an adjustment, the ink height was set to a Z of 0.09 mm and the flow was set to an E of -10 um.
## In this case, to make an adjustment, the ink height was set to a Z of 0.09 mm and the flow was set to an E of -10 um.
## Click "Next."
## Click "Next."
## Wipe the board clean a final time.
## Wipe the board clean a final time.
## Click "Next."
## Click "Next." <br /><br />
# ''Top Layer Print''
# ''Top Layer Print''
## The Voltera will print what is green. Ensure the portion you want to print is selected. Blue lines will not be printed. (Insert pic that i snipped)
## The Voltera will print what is green. Ensure the portion you want to print is selected. Blue lines will not be printed. (Insert pic that i snipped)