1,341
edits
Changes
Jump to navigation
Jump to search
Line 60:
Line 60: − + Line 85:
Line 85: − + − + + + + + + + + + + + + +
→Level 1
## Open the Voltera Windows application.
## Open the Voltera Windows application.
## Select "Print" and then "Simple."
## Select "Print" and then "Simple."
## Select the proper conductive ink. This is the same conductive ink you acquired in step 1.3.
## Add the proper conductive ink. This is the same conductive ink you acquired in step 1.3.
## Load the ink file. This is the Top Layer Gerber file. Download it <u>here.</u>
## Load the ink file. This is the Top Layer Gerber file. Download it <u>here.</u>
## Click "Next."
## Click "Next."
## Remove the probe, replace the cap, place the probe back in the drawer, and click "Next."
## Remove the probe, replace the cap, place the probe back in the drawer, and click "Next."
# ''Priming the Conductor''
# ''Priming the Conductor''
## Hold on to your hats, folks.
## Ensure 15 minutes have passed before beginning the next step. The dispenser should not be cold to the touch.
## EXPLAIN THE PROCESSS LATER
## Mount the dispenser.
## Click Advanced. Move the z to about 10 mm to start. and e of 0. ADjust from here
## Click calibrate.
## The voltera will lay down a test ink. Check for the amount of ink.
## Fig 1 has slghtly too much. The ink height was reduced by 0.01 mm and the flow was eedued by 10 um (so e: -10 um and z: 0.09 mm)
## Fig 2 is just right.
## CLick next
## Wipe clean, and wipe clean each time you test too above
## Click next.
## The voltera will print what is green. Esure the portion you want to print is selected. Blue lines will not be printed
## CLick start
##
=== Level 2 ===
=== Level 2 ===
CHANGE this: <s>After completing the Hello World tutorial, you can proceed with making double-sided boards. Voltera has a tutorial called "Punk Console" which walks through creating your own double-sided board. It also shows how to use the V-One drill to make vias and component through-holes.</s>
CHANGE this: <s>After completing the Hello World tutorial, you can proceed with making double-sided boards. Voltera has a tutorial called "Punk Console" which walks through creating your own double-sided board. It also shows how to use the V-One drill to make vias and component through-holes.</s>