Line 1: |
Line 1: |
| + | [[Category:Proposed deletion]] |
| + | |
| {{#set: | | {{#set: |
− | |Is equipment=True | + | |Is equipment= |
− | |Is located in facility=Welding Shop | + | |Is located in facility= |
| |Is used in domain= | | |Is used in domain= |
| |Has icon=File:image_pending.png | | |Has icon=File:image_pending.png |
Line 10: |
Line 12: |
| |Has description=(???) | | |Has description=(???) |
| |Has certification=(???) | | |Has certification=(???) |
− | |Has make= | + | |Has make= Miller |
− | |Has model= | + | |Has model= Spectrum 875 |
| }} | | }} |
| [[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|100px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]] | | [[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|100px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]] |
− | [[{{#show: {{FULLPAGENAME}}|?Has image|link=none}}|300px|thumb|upright=1.5|{{#show: {{FULLPAGENAME}}|?Has imagedesc}}]]<br /> | + | [[File:Plas.jpg|thumb]] |
− | Test.
| + | <br />Miller Spectrum® 875 Plasma Cutter with 20 foot XT60 torch has compact size but 60 amps of output power. |
| + | |
| + | It features easy operator controls, for optimum cutting and gouging performance. |
| + | |
| | | |
− | Some more test.
| + | = Documentation: = |
| + | https://www.millerwelds.com/files/owners-manuals/o242880c_mil.pdf |
| | | |
− | Wow look at all these tests.
| + | = Procedures: = |
| + | # Place fume hood over the area you will be welding at |
| + | # Turn air on |
| + | # Turn plasma cutter on |
| + | # Attach ground clamp |
| + | # Measure thickness of material being cut and refer to chart for current setting on machine |
| + | # Set the current on the plasma cutter |
| + | # Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down. |
| + | # Raise the trigger lock and press the trigger, this will engage the pilot arc |
| + | # Once the cutting starts, begin to slowly move the torch across the metal |
| + | # Adjust your speed so the sparks go thru the metal and out the bottom of the cut |
| + | # At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger |
| + | # Turn off machine |
| + | # Turn off air |
| + | # Disconnect ground clamp |
| | | |
− | = Test = | + | = Warnings: = |
− | Test
| + | # Don't cut lead, zinc, copper, cadmium, stainless, or beryllium. |
| + | # Don't attempt to cut with the oxygen off |
| + | # Don’t cut with the vent hood off |