Line 1: |
Line 1: |
− | blah blah blah
| + | [[Category:Proposed deletion]] |
| + | |
| + | {{#set: |
| + | |Is equipment= |
| + | |Is located in facility= |
| + | |Is used in domain= |
| + | |Has icon=File:image_pending.png |
| + | |Has icondesc=Add description |
| + | |Has iconwname= |
| + | |Has image=File:image_pending.png |
| + | |Has imagedesc=Image description here |
| + | |Has description=(???) |
| + | |Has certification=(???) |
| + | |Has make= Miller |
| + | |Has model= Spectrum 875 |
| + | }} |
| + | [[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|100px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]] |
| + | [[File:Plas.jpg|thumb]] |
| + | <br />Miller Spectrum® 875 Plasma Cutter with 20 foot XT60 torch has compact size but 60 amps of output power. |
| + | |
| + | It features easy operator controls, for optimum cutting and gouging performance. |
| + | |
| + | |
| + | = Documentation: = |
| + | https://www.millerwelds.com/files/owners-manuals/o242880c_mil.pdf |
| + | |
| + | = Procedures: = |
| + | # Place fume hood over the area you will be welding at |
| + | # Turn air on |
| + | # Turn plasma cutter on |
| + | # Attach ground clamp |
| + | # Measure thickness of material being cut and refer to chart for current setting on machine |
| + | # Set the current on the plasma cutter |
| + | # Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down. |
| + | # Raise the trigger lock and press the trigger, this will engage the pilot arc |
| + | # Once the cutting starts, begin to slowly move the torch across the metal |
| + | # Adjust your speed so the sparks go thru the metal and out the bottom of the cut |
| + | # At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger |
| + | # Turn off machine |
| + | # Turn off air |
| + | # Disconnect ground clamp |
| + | |
| + | = Warnings: = |
| + | # Don't cut lead, zinc, copper, cadmium, stainless, or beryllium. |
| + | # Don't attempt to cut with the oxygen off |
| + | # Don’t cut with the vent hood off |