View source for Miller Spectrum 875 Plasma Cutter

[[Category:Proposed deletion]]

{{#set:
 |Is equipment=
 |Is located in facility=
 |Is used in domain=
 |Has icon=File:image_pending.png
 |Has icondesc=Add description
 |Has iconwname=
 |Has image=File:image_pending.png
 |Has imagedesc=Image description here
 |Has description=(???)
 |Has certification=(???)
 |Has make= Miller
 |Has model= Spectrum 875
}}
[[{{#show: {{FULLPAGENAME}}|?Has icon|link=none}}|100px|left|top|{{#show: {{FULLPAGENAME}}|?Has icondesc}}]]
[[File:Plas.jpg|thumb]]
<br />Miller Spectrum® 875 Plasma Cutter with 20 foot XT60 torch has compact size but 60 amps of output power. 

It features easy operator controls, for optimum cutting and gouging performance.


= Documentation: =
https://www.millerwelds.com/files/owners-manuals/o242880c_mil.pdf

= Procedures: =
# Place fume hood over the area you will be welding at
# Turn air on
# Turn plasma cutter on
# Attach ground clamp
# Measure thickness of material being cut and refer to chart for current setting on machine
# Set the current on the plasma cutter
# Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down.
# Raise the trigger lock and press the trigger, this will engage the pilot arc
# Once the cutting starts, begin to slowly move the torch across the metal
# Adjust your speed so the sparks go thru the metal and out the bottom of the cut
# At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger
# Turn off machine
# Turn off air
# Disconnect ground clamp

= Warnings: =
# Don't cut lead, zinc, copper, cadmium, stainless, or beryllium.
# Don't attempt to cut with the oxygen off
# Don’t cut with the vent hood off