2,297
edits
Changes
Jump to navigation
Jump to search
Line 99:
Line 99: − +
→General Procedure
6. Make sure the machine table is clear and press the power on switch for the jointer and dust collector.
6. Make sure the machine table is clear and press the power on switch for the jointer and dust collector.
7. Position your hands safely on the material. A push stick is needed if your material is less than 2" thick. This will keep your fingers away from the cutter head.
7. Position your hands safely on the material. A hold down or push stick is needed if your material is less than 2" thick. This will keep your fingers away from the cutter head.
8. Slowly feed the material through on the table to get a smooth finish.
8. Slowly feed the material through on the table to get a smooth finish.