1,947
edits
Changes
Jump to navigation
Jump to search
Line 66:
Line 66: − 4. Check that the dust collector is connected. + − 4. Make sure the machine table is clear and press the power on switch for the jointer and dust collector. + − 5. Position your hands safely on the material and use a push stick if needed. A push stick is needed if your material is less than 2" thick. This will keep your fingers away from the cutter head. + − 6. Slowly feed the material through on the table to get a smooth finish. + − 7. After making a pass inspect the material to see if another pass is needed. Multiple passes are normally required to get the desired results. + − 8. Power off the machine and dust collector.+ − 9. Reset the space.+ Line 90:
Line 90: − 4. Check that the dust collector is connected. + − 4. Make sure the machine table is clear and press the power on switch for the jointer and dust collector. + − 5. Position your hands safely on the material and use a push stick if needed. + − 6. Slowly feed the material through on the table to get a smooth finish. + − 7. After making a pass inspect the material to see if another pass is needed. Multiple passes are normally required to get the desired results. + − 8. Power off the machine and dust collector.+ − 9. Reset the space.+
→General Procedure
4. Make sure the fence is tight and set at the correct angle
4. Make sure the fence is tight and set at the correct angle
5. Check that the dust collector is connected.
6. Make sure the machine table is clear and press the power on switch for the jointer and dust collector.
7. Position your hands safely on the material and use a push stick if needed. A push stick is needed if your material is less than 2" thick. This will keep your fingers away from the cutter head.
8. Slowly feed the material through on the table to get a smooth finish.
9. After making a pass inspect the material to see if another pass is needed. Multiple passes are normally required to get the desired results.
10. Power off the machine and dust collector.
11. Reset the space.
Facing Material (planing)
Facing Material (planing)
4. Make sure the fence is tight and set at the correct angle
4. Make sure the fence is tight and set at the correct angle
5. Check that the dust collector is connected.
6. Make sure the machine table is clear and press the power on switch for the jointer and dust collector.
7. Position your hands safely on the material. A push stick is needed if your material is less than 2" thick. This will keep your fingers away from the cutter head.
8. Slowly feed the material through on the table to get a smooth finish.
9. After making a pass inspect the material to see if another pass is needed. Multiple passes are normally required to get the desired results.
10. Power off the machine and dust collector.
11. Reset the space.
==Safety==
==Safety==