1,947
edits
Changes
Jump to navigation
Jump to search
Line 72:
Line 72: − + − + − + − + − − 10. Make sure you keep a firm hold on the material and do not stop feeding the material until it has passed beyond the blade. − − 11. It is helpful to have someone assisting on the back side of the saw to help hold material being fed off the table. Make sure the person helping does not pull on the material. − − 12. When the saw cut is complete, press in on the paddle switch to turn off the saw and lower the blade below the table to keep anyone from accidentally cutting themselves.
→General Procedure
5. Position your hands safely on the material and use a push stick if needed.
5. Position your hands safely on the material and use a push stick if needed.
6. Turn on the main power switch on the front of the saw and the dust collector. The green light on the saw will flash and turn solid green when the saw is ready.
6. Slowly feed the material through on the table to get a smooth finish.
7. Make sure nothing is touching the blade. Turn on the saw by gently pulling on the red start paddle switch located on the front of the machine. The paddle switch is also the off switch when pressed.
7. After making a pass inspect the material to see if another pass is needed. Multiple passes are normally required to get the desired results.
8. Line up the flat side of the material with the fence without touching the blade. The fence is a guide and the material should be pressed firmly into the fence as well as down on the table. If the board is warped make sure that curved side is face downward.
8. Power off the machine and dust collector.
9. Slowly feed the material in towards the blade while keeping your fingers at least 6" from the blade. Use a push stick to keep fingers away from the blade.
9. Reset the space.
==Safety==
==Safety==