Changes

Serial Number: {{#show: {{PAGENAME}} |?Has serial number}}  

Serial Number: {{#show: {{PAGENAME}} |?Has serial number}}  

Ace: Kyler Howard (khoward19@georgefox.edu).

Ace: Ellie Annah (estrauss21@georgefox.edu).

Location: {{#show: {{PAGENAME}} |?Is located in facility}}

Location: {{#show: {{PAGENAME}} |?Is located in facility}}

#Flip the rocker switch on the bottom right to turn the bath on.

#Flip the rocker switch on the bottom right to turn the bath on.

#Select the temperature that correlates to your print material (70 degrees for ABS) and press the power button to begin the heating process.

#Select the temperature that correlates to your print material (70 degrees for ABS) and press the power button to begin the heating process.

#Keep the lid shut as often as possible.

#Keep the lid shut as much as possible.

#Place the part inside of a mesh bag, tie the strings of the mesh bag to the side handles, allow the part to soak in the bath for several hours.

#Place the part inside of a mesh bag, tie the strings of the mesh bag to the side handles, allow the part to soak in the bath for several hours.

#*Mesh bags are located in the small drawer next to the sink.

#*Mesh bags are located in the small drawer next to the sink.