1,956
edits
Changes
Jump to navigation
Jump to search
Line 51:
Line 51: + + + +
→2. Reset the Space
When using the electronics station, it is, as always, imperative that you RESET THE SPACE. Clean up all solder paste, stripped wires, etc., and put everything back where you found it, putting the cables back where they go.
When using the electronics station, it is, as always, imperative that you RESET THE SPACE. Clean up all solder paste, stripped wires, etc., and put everything back where you found it, putting the cables back where they go.
There is an end cabinet located at the end of the Low-Fidelity Prototyping Station that holds papers and materials as well as scrap cardboard. If there is room, feel free to add scrap cardboard (from shipped boxes, etc.) to keep this supply stocked.
For the other materials, if they are low or empty, please notify the toolroom so that supplies can be restocked. As always, when finished, RESET THE SPACE. Clean up the table and make sure that the bins are orderly.
On the wall are a set of tools. These are available for use within the Maker Hub. As should be obvious, when you are done using the tools, return them - RESET THE SPACE. For example, if you use a tool put it back when you are done. Not much of an example. Sort of hard to make this any more clear. Let’s say it is a wrench - and you use it. When you are done - put it back. Get it? The tools are marked with blue paint to indicate they belong in the Maker Hub.
On the wall are a set of tools. These are available for use within the Maker Hub. As should be obvious, when you are done using the tools, return them - RESET THE SPACE. For example, if you use a tool put it back when you are done. Not much of an example. Sort of hard to make this any more clear. Let’s say it is a wrench - and you use it. When you are done - put it back. Get it? The tools are marked with blue paint to indicate they belong in the Maker Hub.