Changes

====General Procedure====

====General Procedure====

# Setup

# Setup

## Depending on the material being used you may want to preheat the mold. If a hot plate is available, preheat the aluminum mold to prevent plastic cooling too fast by placing the mold on the hot plate and heating to a specific temperature. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]

## You will need to setup the molding machine using the following steps and charts. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]

## Next we need to adjust the height by following these steps.  

## First we need to adjust the height for the mold being used by following these steps.  

### Set the mold clamps to measure the gap.  

### Set the mold clamps to measure the gap.  

### Loosen the height adjustment bolts on the top holder using a 6mm Allen Wrench.

### Loosen the height adjustment bolts on the top holder using a 6mm Allen Wrench.