Changes

Jump to navigation Jump to search
Line 63: Line 63:  
====General Procedure====
 
====General Procedure====
 
# Setup
 
# Setup
## First we have to Preheat the mold. If a hot plate is available, preheat the aluminum mold to prevent plastic cooling too fast by placing the mold on the hot plate and heating to a specific temperature. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]
+
## Depending on the material being used you may want to preheat the mold. If a hot plate is available, preheat the aluminum mold to prevent plastic cooling too fast by placing the mold on the hot plate and heating to a specific temperature. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]
 
## Next we need to adjust the height by following these steps.  
 
## Next we need to adjust the height by following these steps.  
 
### Set the mold clamps to measure the gap.  
 
### Set the mold clamps to measure the gap.  
1,956

edits

Navigation menu