Changes

## You should see a small amount of plastic ooze from the nozzle

## You should see a small amount of plastic ooze from the nozzle

## Make sure the mold is clamped tight and the nozzle nipple is aligned with the mold sprue.   

## Make sure the mold is clamped tight and the nozzle nipple is aligned with the mold sprue.   

## Scrape away any oozing plastic from the nozzle using a screwdriver or similar tool.  

## Scrape away any oozing plastic from the nozzle using a screwdriver or similar tool. This helps keep plastic chunks out of the mold. 

## With a smooth linear motion push down on the handle and fill the mold.   

## With a smooth linear motion push down on the handle and fill the mold.   

## Hold pressure on the handle for an extra few seconds.

## Hold pressure on the handle for an extra few seconds. This will help reduce shrinking of the plastic in the mold. 

## Retract the handle all of the way to remove the plunger and give access to load more pellets.  

## Retract the handle all of the way to remove the plunger and give access to load more pellets.  

## You can now remove the mold and separate the halves.

## You can now remove the mold and separate the halves.