1,956
edits
Changes
Jump to navigation
Jump to search
Line 80:
Line 80: − +
→Troubleshooting
==Troubleshooting==
==Troubleshooting==
It may take some time to learn how to apply the correct amount of pressure to apply to the handle when filling a mold. If you press too hard you will end up with lots of plastic flash on your finished piece. If you don't press hard enough you could end up with an air pocket left in the mold.
It may take some time to learn how much pressure to apply to the handle when filling a mold. If you press too hard you will end up with lots of plastic flash on your finished piece as material will ooze out between the molds halves. If you don't press hard enough you could end up with an air pocket left in the mold.
==Maintenance==
==Maintenance==