Changes

1. Ensure that the material you are cutting is free from nails or foreign objects.  Foreign material will damage the cutters and create flying hazards.  

1. Ensure that the material you are cutting is free from nails or foreign objects.  Foreign material will damage the cutters and create flying hazards.  

2. Make sure the board is at least 10" long and xxx" wide  to prevent the board from tilting while cutting.  

2. Make sure the board is at least 10" long and 1" wide  to prevent the board from tilting while cutting.  

3. Check the cut gauge on the front table. Make sure you know how much material is being removed. Never adjust the rear table.  

3. Check the cut gauge on the front table. Make sure you know how much material is being removed. Never adjust the rear table.  

4. Make sure the machine table is clear and press the power on switch for the jointer and dust collector.  

4. Make sure the machine table is clear and press the power on switch for the jointer and dust collector.  

5. Position your hands safely on the material and use a push stick if needed.  

5. Position your hands safely on the material and use a push stick if needed. A push stick is needed if your material is less than 2" thick.  This will keep your fingers away from the cutter head. 

6. Slowly feed the material through on the table to get a smooth finish.  

6. Slowly feed the material through on the table to get a smooth finish.