Changes

====General Procedure====

====General Procedure====

This video contains specific information for using the Mills in the Maker Hub as well as a basic overview of what will be expected in your live demonstration. {{#evu:https://www.youtube.com/watch?v=IJjXAxYH9TA}}Note that the tool changing system has been upgraded since this video was made. To insert a cutting tool under the new system, push the tool upwards into the collet with one hand and then push quill handle up with the other to compress the spring above the collet. Pushing up on the quill handle will allow the the tool to slide up into the collet and the tool will lock in place once the handle is lowered. A decent amount of force is required to compress the spring so don't be afraid to push hard. To release the tool, hold it in one hand while pushing up on the quill handle and then pull it out once the spring is compressed.  

This video contains specific information for using the Mills in the Maker Hub as well as a basic overview of what will be expected in your live demonstration. {{#evu:https://www.youtube.com/watch?v=IJjXAxYH9TA}}'''Note''' that the tool changing system has been upgraded since this video was made. To insert a cutting tool using the new system, push the collet upwards into the spindle with one hand and then push quill handle against the quill end of travel with the other to compress the spring in the tool change mechanism. Pushing up on the quill handle will allow the the tool to slide up into the collet and the tool will lock in place once the handle is lowered. A decent amount of force is required to compress the spring so don't be afraid to push hard. To release the tool, hold it in one hand while pushing up on the quill handle and then pull it out once the spring is compressed.

== Safety ==

== Safety ==