Changes

Loading Material:

Loading Material:

# Turn on power.

# Turn on power.

# Feed material through back of machine, vacuum should engage.

# Feed material through back of machine; the vacuum should engage.

# Align material with the rollers so it is covered at both corners and within the center if needed.

# Align material with the rollers so it is covered at both corners and within the center if needed.

## Rollers can only be placed within the shiny silver strips located along the front of the cutter, above the header.

## Rollers can only be placed within the shiny silver strips located along the front of the cutter, above the header.

# If possible, leave an inch or two of excess material hanging down below the cutting head.

# If possible, leave an inch or two of excess material hanging down below the cutting head.

# Use the arrow pad to select the type of media: roll, piece, etc.

# Use the arrow pad to select the type of media: roll, piece, etc.

# Press [ENTER].

# Press [ENTER] to secure the material.

# Move the cutting head to the left of the stock via the directional keys, then hold [ORIGIN] to set the starting point of the cut.

# Move the cutting head to the left of the stock via the directional keys, then hold [ORIGIN] to set the starting point of the cut.

Prepping/Cutting a Graphic:

Prepping/Cutting a Graphic: