479
edits
Changes
Jump to navigation
Jump to search
Line 98:
Line 98: − === Common Errors === − If a print fails, the most likely cause is contamination of the resin. Before proceeding, see the procedure for Failed Prints. Contamination of the resin involves leftover material on the build plate, or particulates in the resin tank. Before attempting a new print, thoroughly clean the build plate, and dredge the resin tank for any loose particles. Another cause is incorrect orientation of the print. Check the print file in question, and ensure it has been canted accordingly to prevent the de-laminating process from removing the print from the build plate. '''Don't ever mix resin types.''' − − Old resin and resin tanks can also present issues. If a resin tanks is particularly cloudy on the bottom, the laser will be prevented from being able to penetrate the tank, and cause adhesion issues for the print. Resin can also go bad after sitting for long periods of time or being used heavily. This can be evidenced by discoloration of the resin or separation of the resin into unmixed layers. − − === Maintenance === − * Dredging: Every few prints the resin tank should be dredged with a scraping tool to search for any hardened resin or loose bits of material, when resin tanks are switched out, and when a print fails. Remove any found bits. Dredging is done by sweeping a scraping tool back and forth across the bottom of the resin tank, essentially mixing up the resin to stir up any loose bits. Take care while dredging to not scrape the tank. See a resin's particular page on the Formlabs website for additional cleaning instruction. If the tank is not cleanable, switch out the resin tank. If the problem persists, it's possible the resin cartridge needs to be switched out as well. − * Alcohol in the Form Wash must be changed once a certain threshold of washed-off resin enters the tank. See the [[Form Wash and Cure]] page for details. − * Old resin and resin tanks will occasionally need to be changed out − − * [https://support.formlabs.com/hc/en-us/categories/115000003904-Form-2 Form 2 Sources and Help]
→Common Errors
# Washing and Curing Prints
# Washing and Curing Prints
## See the [[Form Wash and Cure]] page.
## See the [[Form Wash and Cure]] page.
==Safety==
==Safety==