479
edits
Changes
Jump to navigation
Jump to search
Line 75:
Line 75: − + − + + + + + +
→General Procedure
Using the Voltera to create single-sided boards with NO vias or holes.[[File:voltera_blinky_500.jpg|300x300px|thumb|right|Training board - The Blinky 500]]
Using the Voltera to create single-sided boards with NO vias or holes.[[File:voltera_blinky_500.jpg|300x300px|thumb|right|Training board - The Blinky 500]]
# Drilling
# Drilling
## This board in particular does not have any holes, so this entire step can be skipped for this procedure, however, these are the steps to take if you need to drill holes in the future.
## '''This board in particular does not have any holes, so this entire step can be skipped for this procedure''', however, these are the steps to take if you need to drill holes in the future.
##
## After opening the Voltera software, select Drill. This option is chosen only if you want to add holes to an existing board.
## For Drilling, you can either choose the Simple or Aligned route. Choose Simple if your board has no existing features, and choose Aligned if your board has some existing features. Lets go through the process for both.
## Drilling for a Simple Board
### fsa
## Drilling for an Aligned Board
## fdsa
# Ready the Ink
# Ready the Ink
## The ink is most usable when it reaches room temperature, so we have to let it warm up in advance.
## The ink is most usable when it reaches room temperature, so we have to let it warm up in advance.