Changes

## During the probing process, be sure that your board is completely flat and that the clamps cover a minimal amount of the board while keeping it secure. If the probing hits the claps or runs off the board, the calibration is no good. Go back to the initial stages where you align holes/indicate where to print traces.

## During the probing process, be sure that your board is completely flat and that the clamps cover a minimal amount of the board while keeping it secure. If the probing hits the claps or runs off the board, the calibration is no good. Go back to the initial stages where you align holes/indicate where to print traces.

## When holes are available during the Alignment stage, always use them to align your board. NEVER use pads or traces unless you absolutely have to. Holes are much easier to align with.

## When holes are available during the Alignment stage, always use them to align your board. NEVER use pads or traces unless you absolutely have to. Holes are much easier to align with.

# Printing Traces

# Printing Traces/Solder

## Be sure that the dispenser has been warming up to room temperature for at least 15 minutes so the ink can flow smoothly.  

## Be sure that the dispenser has been warming up to room temperature for at least 15 minutes so the ink can flow smoothly.  

## If the ink does not seem come come out even when you're priming the dispenser, chances are that it is clogged. Remove the tip, notify a PCB Lab worker, and install a new tip (ask a worker if you don't know how).

## If the ink does not seem come come out even when you're priming the dispenser, chances are that it is clogged. Remove the tip, notify a PCB Lab worker, and install a new tip (ask a worker if you don't know how).

==Maintenance==

==Maintenance==

====General maintenance====

====General maintenance====

====Specific Maintenance Tasks====

====Specific Maintenance Tasks====