Changes

4. Lock the fence by pressing down on the locking handle.

4. Lock the fence by pressing down on the locking handle.

5. Use the blade lift handle on the front of the saw to set the height of the blade approximately 1 tooth above the height of the material.  Use the material as a gauge.   

5. Use the blade lift handle on the front of the saw to set the height of the blade approximately 1 tooth above the height of the material.  Use the material as a gauge.   

6. Turn on the power switch on the front of the saw and the dust collector. The green light on the saw will flash and turn solid when the saw has booted.  

6. Turn on the power switch on the front of the saw and the dust collector. The green light on the saw will flash and turn solid when the saw has booted.  

7. Make sure nothing is touching the blade.  Turn on the saw by gently pulling on the paddle switch located on the front of the machine. The paddle switch is also the off switch.   

7. Make sure nothing is touching the blade.  Turn on the saw by gently pulling on the paddle switch located on the front of the machine. The paddle switch is also the off switch.   

8. Line up the flat side of the material with the fence without touching the blade. The fence is a guide and the material should be pressed firmly into the fence as well as down on the table.  

8. Line up the flat side of the material with the fence without touching the blade. The fence is a guide and the material should be pressed firmly into the fence as well as down on the table.  

9. Slowly feed the material in towards the blade while keeping your fingers clear of the blade.  Use a push stick to keep your fingers away from the blade.  

9. Slowly feed the material in towards the blade while keeping your fingers clear of the blade.  Use a push stick to keep your fingers away from the blade.  

10. Make sure you keep a firm hold on the material and do not stop feeding the material until it has passed beyond the blade.  

10. Make sure you keep a firm hold on the material and do not stop feeding the material until it has passed beyond the blade.  

11. It is helpful to have someone assisting on the back side of the saw to help hold material being fed off the table.  

11. It is helpful to have someone assisting on the back side of the saw to help hold material being fed off the table.  

12. When you are done with the saw cut press in on the paddle switch to turn off the saw.

12. When you are done with the saw cut press in on the paddle switch to turn off the saw.