Changes

#Begin by tracing the area of your desired bead on the sheet metal.

#Begin by tracing the area of your desired bead on the sheet metal.

#Next, loosen the tensioning bolt, and place the sheet metal between the two forming dies.  

#Next, loosen the tensioning bolt, and place the sheet metal between the two forming dies.  

#Tighten the tensioning bolt by turning it two revolutions after both dies contact the sheet metal.  

#Tighten the tensioning bolt by turning it two revolutions after both dies contact the sheet metal. Make sure the sheet metal is contacting the traced line where you would like the bead to begin.  

# Turn the handle on the opposite side as you guide the metal through the dies. It may be easier to have a second person do this to allow the first person to more accurately guide the sheet metal through the beads.

# Turn the handle on the opposite side as you guide the metal through the dies. It may be easier to have a second person do this to allow the first person to more accurately guide the sheet metal through the beads.

#  

#