191
edits
Changes
Jump to navigation
Jump to search
Line 35:
Line 35: +
→Bending Steps
#Insert your work piece to the line you want to bend, centered in the brake, and clamp your piece securely.
#Insert your work piece to the line you want to bend, centered in the brake, and clamp your piece securely.
#Pull up on the bending handle of the leaf slowly until your piece is bent to the desired angle, and slowly lower the leaf.
#Pull up on the bending handle of the leaf slowly until your piece is bent to the desired angle, and slowly lower the leaf.
#If the piece does not bend straight, unclamp the handle on the overbent side and adjust the top leaf.
#Adjust the clamp handle, and remove your piece.
#Adjust the clamp handle, and remove your piece.
#Put back any fingers if adjusted, and deburr if any rough edges are left.
#Put back any fingers if adjusted, and deburr if any rough edges are left.