Changes

* If a window pops up saying the print is broken, hit the repair button then proceed as normal

* If a window pops up saying the print is broken, hit the repair button then proceed as normal

* Parts must be shrunk to fit within the build area, further size edits can be made in the Size tab

* Parts must be shrunk to fit within the build area, further size edits can be made in the Size tab

[[File:Model too big.jpg|none|thumb]]

[[File:Model too big.jpg|none|thumb|302x302px]]

* All prints should be slightly canted (angled) to prevent the delamination process from removing the print from the build plate

* All prints should be slightly canted (angled) to prevent the delamination process from removing the print from the build plate

** The goal is to reduce the horizontal area covered with each pass of the wiper

** The goal is to reduce the horizontal area covered with each pass of the wiper