91
edits
Changes
Jump to navigation
Jump to search
Line 19:
Line 19: − + − Test+ + + + + + + + + + + + + + + + + + + + + + +
no edit summary
* [ https://www.millerwelds.com/files/owners-manuals/o1325a_mil.pdf ]
* [ https://www.millerwelds.com/files/owners-manuals/o1325a_mil.pdf ]
= Test =
= Procedures: =
'''Procedures:'''
Prior to Welding
# Place the fume hood over the area you will be welding at
# Attach the ground clamp to the bench your workpiece will be on
# Ensure the workpiece is touching the conductive surface of the table
# Ensure the adjusting screw on the tank regulator is loose (Do not unscrew all the way)
# Open cylinder valve all the way
# Turn the adjusting screw (clockwise) to increase pressure to 15 CFH.
# Identify material type and thickness that is going to be welded
# Refer to MIG welding chart for specified adjustments, specific to your application
# Turn on the welder and adjust wire speed and voltage
# Ensure you are wearing all necessary protective gear
# Ensure the welding torch has proper amount of wire protruding from tip (about ¼ inch) If too long, trim excess with the welding pliers.
# Weld!
After Welding
# Close gas cylinder valve
# Bleed remaining gas by depressing trigger until regulator drops to 0
# Back out adjusting screw on regulator (Do Not unscrew all the way)
# Turn off the welder
# Remove ground clamp