1,341
edits
Changes
Jump to navigation
Jump to search
Line 86:
Line 86: − + − + Line 99:
Line 99: − + + + + + + +
→Level 1
# ''Priming the Conductor''
# ''Priming the Conductor''
## Ensure 15 minutes have passed before beginning the next step. The dispenser should not be cold to the touch.
## Ensure 15 minutes have passed before beginning the next step. The dispenser should not be cold to the touch.
## EXPLAIN THE PROCESSS LATER
## EXPLAIN THIS AWFUL PROCESS
## Mount the dispenser.
## Mount the dispenser.
## Click Advanced. Move the z to about 10 mm to start. and e of 0. ADjust from here
## Click "Advanced." Start with the Z at 0.10 mm to start e of 0. ADjust from here
## Click calibrate.
## Click calibrate.
## The voltera will lay down a test ink. Check for the amount of ink.
## The voltera will lay down a test ink. Check for the amount of ink.
## CLick start
## CLick start
## Let the voltera finsih. if a portion is not right, you can stop mid print, or wait till it is finsihed and redo that selection. Fig 3 is an example of a portion of ink that globbed up. The portion was wiped and can be reprinted.
## Let the voltera finsih. if a portion is not right, you can stop mid print, or wait till it is finsihed and redo that selection. Fig 3 is an example of a portion of ink that globbed up. The portion was wiped and can be reprinted.
##
## Remove the conductor, replace the cap, AND PUT IT IN THE FRIDGE.
## When you reach the "Flip Board," you are done. Quit the voltera app
## Power on.
## Select V1 INK
## The reflow will warm up. When its ready, press enter to open the tray
## Place the board securely on the rails.
## Press enter to close the tray. The preheat will take 2 minutres This reflow takes about 30 min.
=== Level 2 ===
=== Level 2 ===
CHANGE this: <s>After completing the Hello World tutorial, you can proceed with making double-sided boards. Voltera has a tutorial called "Punk Console" which walks through creating your own double-sided board. It also shows how to use the V-One drill to make vias and component through-holes.</s>
CHANGE this: <s>After completing the Hello World tutorial, you can proceed with making double-sided boards. Voltera has a tutorial called "Punk Console" which walks through creating your own double-sided board. It also shows how to use the V-One drill to make vias and component through-holes.</s>