142
edits
Changes
Jump to navigation
Jump to search
Line 19:
Line 19: − + + + − +
→General 3D Printing Knowledge
**Adding a raft (sometimes called a brim) will also help if you print is struggling with staying adhered to the plate.
**Adding a raft (sometimes called a brim) will also help if you print is struggling with staying adhered to the plate.
*Clogging
*Clogging
**
**Sometimes the extruder will clog causing the print to fail.
**This typically can be seen when a clump of filament balls up at the end of the nozzle.
**If this occurs, immediately cancel the print and remove the clumped filament. Make sure that the nozzle is still able to extrude filament, if not, you may need to open up the extruder and clean it. Keep working on it until you are able to extrude filament again.
*Air Extruding
*Air Extruding
**
**This means that the extruder thinks it is extruding filament when it really is not.
==General Laser Cutting Knowledge==
==General Laser Cutting Knowledge==