142
edits
Changes
Jump to navigation
Jump to search
Line 36:
Line 36: +
no edit summary
*** The build platform will lower again, and the process will be repeated until the print is completed.
*** The build platform will lower again, and the process will be repeated until the print is completed.
*** Due to friction caused by de-laminating every layer, every part should be canted in its orientation. This means the part should be angled to reduce the cross sectional area needing to be shifted to de-laminate each layer.
*** Due to friction caused by de-laminating every layer, every part should be canted in its orientation. This means the part should be angled to reduce the cross sectional area needing to be shifted to de-laminate each layer.
*** Once a part is finished on the Form 2, it must be removed off of the build plate, any excess resin must washed off using the Form Wash, the part must be air dried so that any alcohol from the Wash has evaporated, supported must be clipped off, and the part should be cured in the Form Cure.