411
edits
Changes
Jump to navigation
Jump to search
→Demonstration
Line 55:
Line 55:
Insert text+
====Demonstration====
====Demonstration====
−To demonstrate competency on the Bending brake you will be required to bend a sheet metal to a 90 degree angle.
====General Procedure====
====General Procedure====
Line 65:
Line 65:
#Insert your work piece to the line you want to bend, centered in the brake, and clamp your piece securely.
#Insert your work piece to the line you want to bend, centered in the brake, and clamp your piece securely.
#Pull up on the bending handle of the leaf slowly until your piece is bent to the desired angle, and slowly lower the leaf.
#Pull up on the bending handle of the leaf slowly until your piece is bent to the desired angle, and slowly lower the leaf.
−#If the piece does not bend straight, unclamp the handle on the overbent side and adjust the top leaf.
+#If the piece does not bend straight, unclamp the handle on the over-bent side and adjust the top leaf.
#Adjust the clamp handle, and remove your piece.
#Adjust the clamp handle, and remove your piece.
#Put back any fingers if adjusted, and deburr if any rough edges are left.
#Put back any fingers if adjusted, and deburr if any rough edges are left.