Difference between revisions of "Heat Press"
| Line 35: | Line 35: | ||
* Pressure Adjustment Knob - The knob located over the center of the upper platen which is used to adjust the pressure applied to the material. | * Pressure Adjustment Knob - The knob located over the center of the upper platen which is used to adjust the pressure applied to the material. | ||
* Lift Handle - The large handle used to raise or lower the upper platen | * Lift Handle - The large handle used to raise or lower the upper platen | ||
| − | + | [[File:Heat Press Terminology .jpg|center|frame|573x573px]] | |
This manual covers the use, calibration, and safety of the heat press. | This manual covers the use, calibration, and safety of the heat press. | ||
Revision as of 09:48, 30 May 2019
Model: Stahls MAXX Clam Heat Press
Serial Number:
Ace: Needed (Makerhub@georgefox.edu).
Description
The heat press is a machine used to transfer graphics onto items like T-shirts, bags, jerseys and more. Materials that can be transferred include heat transfer vinyl (HTV), screen printed transfers, rhinestones, and more. Within the Hub, the heat press works in conjunction with the vinyl printer and cutter to adhere vinyl to cloth and is commonly used to make custom t-shirts or to add logos to clothing. A brief video about the heat press can be seen here.
Documentation
Terminology:
- Platen - The flat plates on the top and bottom of the machine which apply pressure to the material along with heat.
- Pressure Adjustment Knob - The knob located over the center of the upper platen which is used to adjust the pressure applied to the material.
- Lift Handle - The large handle used to raise or lower the upper platen
This manual covers the use, calibration, and safety of the heat press.
Training
The heat press can press heat transfer applications into many materials. Be sure to check the instructions for your type of heat transfer material before pressing.
Certification
Troubleshooting
Maintenance
Due to its simplicity and limited number of moving parts this machine requires a minimal amount of maintenance. The little maintenance required consists of wiping down the machine after each use to ensure there is no dust or vinyl transferring left on the machine. To do this, grab a paper towel from either the prototype lab or the sink next to the tool room and wipe over the machine. Pay special attention to the upper platen as it is the surface that transfers heat to the vinyl. For more information on when this should be done and who should do it see the table below.
| Maintenance Procedure | Frequency | Done By |
|---|---|---|
| Machine wipe down | After each use | The student |