Revision as of 14:20, 11 February 2019

Image description here

Test.

Some more test.

Wow look at all these tests.

Procedures:

Place fume hood over the area you will be welding at
Turn air on
Turn plasma cutter on
Attach ground clamp
Measure thickness of material being cut and refer to chart for current setting on machine
Set the current on the plasma cutter
Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down.
Raise the trigger lock and press the trigger, this will engage the pilot arc
Once the cutting starts, begin to slowly move the torch across the metal
Adjust your speed so the sparks go thru the metal and out the bottom of the cut
At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger
Turn off machine
Turn off air
Disconnect ground clamp

@@ Line 21: / Line 21: @@
 Wow look at all these tests.
-= Test =
+= Procedures: =
-Test
+# Place fume hood over the area you will be welding at
+# Turn air on
+# Turn plasma cutter on
+# Attach ground clamp
+# Measure thickness of material being cut and refer to chart for current setting on machine
+# Set the current on the plasma cutter
+# Place the drag shield on the edge of the base metal, or hold ⅛ inch off the surface. Direct the arc straight down.
+# Raise the trigger lock and press the trigger, this will engage the pilot arc
+# Once the cutting starts, begin to slowly move the torch across the metal
+# Adjust your speed so the sparks go thru the metal and out the bottom of the cut
+# At the end of the cut, angle the torch slightly towards the final edge or pause briefly before releasing the trigger
+# Turn off machine
+# Turn off air
+# Disconnect ground clamp