1,956
edits
Changes
Jump to navigation
Jump to search
Line 63:
Line 63: − +
→General Procedure
====General Procedure====
====General Procedure====
# Setup
# Setup
## You will need to setup the molding machine using the following steps and charts. Temperatures for different plastics can be found in the table below.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]
## You will need to setup the molding machine using the following steps and charts. Temperatures for different plastics can be found in the table below. Make sure to wear gloves and safety glasses while using this machine.[[File:...injectionTemperatureChart.png|none|thumb|373x373px]] [[File:Temp_Controller.JPG|600px|thumb|none]]
## First we need to adjust the height for the mold being used by following these steps.
## First we need to adjust the height for the mold being used by following these steps.
### Set the mold clamps to measure the gap.
### Set the mold clamps to measure the gap.