Ring Roller

Baileigh Ring Roller

Make: Baileigh Industrial

Model: R-M5

Ace: Needed (Makerhub@georgefox.edu).

Location: Machine Shop

Description

A ring roller is a machine used to roll metal into a ring by forcing the material through rollers, also called dies. The rollers can be adjusted to change the formed radius. The maximum mild steel machine capacity is 1/4" x 1" flat bar or 1/2" round rod. The minimum diameter you can form is 2.75"

Here is an example of this piece of equipment being used.

Documentation

Terminology

• Dies - Round pieces of steel used to guide the material as its shaped.

Manual Media:R-M5_07-2019.pdf

Training

Overview

Insert Text

Demonstration

1. Cut a 5 inch long piece of 1" x 1/8" aluminium.
2. Roll the piece to the smallest possible radius. This will not be a full ring.

General Procedure

1. Adjust the knob on the right to adjust the radius, loosen the handle on the left if it restricting you from adjusting the right one.
2. Make sure both knobs are secure and tightened before rolling, always start by rolling the largest radius, and work your way up from there.
3. Insert the bar between the rollers.
4. Turn the crank to roll the metal bar or rod.
5. Start with a large radius and continue to make the radius smaller every time you roll. If you attempt to roll a small radius all at once, the rod may make a corkscrew shape instead of a circle.
6. You have completed the roll when the two ends overlap each other by a couple of inches to account for the ends of the bar or rod that stay straight.

Safety

Insert text

Certification

Foxtale Quiz

Maintenance

General maintenance

Insert text

Specific Maintenance Tasks

Maintenance Procedure	Frequency	Done By
Sample	Sample	Sample