Difference between revisions of "Through Hole Press"
| Line 16: | Line 16: | ||
====Terminology==== | ====Terminology==== | ||
| − | + | <gallery> | |
| − | + | [[File:...rivet.png|Riven]] | |
| + | [[File:...rubberMallet.png|Rubber Mallet]] | ||
| + | </gallery> | ||
User Manual | User Manual | ||
| Line 94: | Line 96: | ||
<br /><br /> | <br /><br /> | ||
| − | <figure-inline><figure-inline>[[File:through hole press chart snippet.PNG|750x750px]]</figure-inline></figure-inline> | + | <figure-inline><figure-inline><figure-inline>[[File:through hole press chart snippet.PNG|750x750px]]</figure-inline></figure-inline></figure-inline> |
<br /><br /> | <br /><br /> | ||
Revision as of 16:11, 18 June 2019
Make: Bungard
Model: PL-FAVORIT
Ace: Isaac Beals (ibeals16@georgefox.edu).
Location: PCB Lab
Description
The Through Hole Press is a hand-operated through hole plating machine using rivets. A rivet is a component used to easily connect traces that are transitioning between the top and bottom layers of a PCB. Specifically, it is a small hollow copper tube that can be inserted on one side of the board, then - using a specialized rivet tool like the Through Hole press - the rivets are pressed and deformed to connect both sides. There are other methods that carry out the same function, but using rivets is the fastest and most consistent method.
Documentation
Terminology
User Manual
Training
Overview
Insert Text
Demonstration
Insert text
General Procedure
Insert text
Safety
Insert text
Certification
Foxtale Quiz
Troubleshooting
Maintenance
General maintenance
Insert text
Specific Maintenance Tasks
| Maintenance Procedure | Frequency | Done By |
|---|---|---|
| Sample | Sample | Sample |
Here would be info about this equipment.
The current Ace of the Through Hole Press is Isaac Beals (ibeals16@georgefox.edu).
Documentation
Training
Rivet and Drill Sizes
Use this information to determine the size hole to drill for the desired rivet.
<figure-inline><figure-inline><figure-inline>
</figure-inline></figure-inline></figure-inline>
Adjusting the Tool Set
Riveting Process