473
edits
Changes
Jump to navigation
Jump to search
Line 103:
Line 103: − + + Line 111:
Line 112: + + − + − + − + + + + + + + + +
no edit summary
* The machine does not cut, many sparks visible. The process table is not set correctly or the cutting head or optics is dirty. Ensure correct focal offset, cut speed, cut height, and gas pressure in process table. Check that the nozzle tip is clean, wipe off slag with Scotchbrite.
* The machine does not cut, many sparks visible. The process table is not set correctly or the cutting head or optics is dirty. Ensure correct focal offset, cut speed, cut height, and gas pressure in process table. Check that the nozzle tip is clean, wipe off slag with Scotchbrite.
* Machine loses cut so that there crooked lines and gaps in the part. Again this is because the process table parameters incorrect or the cutting head/optics are dirty. Verify cut process parameters including cut speed, cut height, and gas pressure. Check nozzle tip is clean, wipe off slag with Scotchbrite.
* Machine loses cut so that there crooked lines and gaps in the part. Again this is because the process table parameters incorrect or the cutting head/optics are dirty. Verify cut process parameters including cut speed, cut height, and gas pressure. Check nozzle tip is clean, wipe off slag with Scotchbrite.
* Cut does not go all the way through material
* Cut does not go all the way through material. Select correct process. Reduce cut speed. Increase assist gas pressure up to 145 PSI. Verify process table is correct. Verify beam centering and focus test. Inspect nozzle tip.
* If your machine has a rotary you may encounter two homing errors. If the touchscreen says, “Idler (the chuck that holds the right side of the tube) not homed. Move idler to home”, open the door and move the idler all the way to the right. There is a sensor that detects when the idler is in its home position. Once the idler is in the home position, close the message and repress HOME THE MACHINE. If you encounter an error message saying that the rotary is locked; simply pull out the red pin, close the message, and repress HOME THE MACHINE.
==Maintenance==
==Maintenance==
====General maintenance====
====General maintenance====
====Specific Maintenance Tasks====
====Specific Maintenance Tasks====
{| class="wikitable"
{| class="wikitable"
!
!Maintenance Procedure
!Maintenance Procedure
!Frequency
!Frequency
!Done By
!Done By
!Last Done
|-
|-
|Sample
|1
|Sample
|General Cleaning
|Sample
|Every 2-3 Weeks depending on usage rate
|Student
|N/A
|-
|2
|
|
|
|
|}
|}